Lilin iMEGAPRO IPR7722ESX Schnellinstallationsanleitung Seite 9

Emergency Factory Default
To restore factory default settings by hardware, please follow these
steps:
1. Hold "RESET Key" for 10 seconds, then release.
2. After about 40 seconds, the network LED light should turn off,
and the back on again.
3. This camera has completed the factory default settings, and can
then reboot.
4. Search for the IP device using the IPScan software.
5. Start the IP device via Internet browser.
6. Enter the default username "admin" and password "pass" to
operate.
NOTE: For user convenience, restoring the factory default settings
will revert to the default IP address 192.168.0.200.
Before Accessing IP Cameras
Before accessing the IP camera, make sure that the camera's RJ-45
network, audio, and power cables are properly connected. To set the
IP address, consult your network administrator for an available IP
address. The default IP address for each IP camera is 192.168.0.200.
Users can use the default IP address for verifying the camera's
network connection.
Software Requirements
Merit LILIN Universal ActiveX software components are required for
web interface display of JPEG or H.264 Full HD video. When you login
to the IP camera by Internet Explorer, the security warning dialog box
will prompt the installation of the LILIN Universal ActiveX. Click Install
to download it.
- 6 -