Strack PowerMax SN5650-PMOL-0065 Bedienungsanleitung Seite 46

PowerMax cam unit SN5650-PMOL-0065 — SN5650-PMOL-0400
5. Design of the PowerMax cams
STRACK NORMA PowerMax cams are produced in a high-precision manner.
The guidances which are grinded to a tight guide clearance allow highest loads. The cam units can be
equipped with the tool on the working surface. In doing so you have to consider that the force affects
in the centre of the working surface.
If you have an off-center load irregular forces
arise on the guidances and produce an increased
wear.
(See 3.1. description of the construction types)
Herefrom you can clearly read the maximal force outside the centre of activity for the x respectively the y
axis. Modifications of position which will be possible in future should be considered previously to choose a
cam size which corresponds to the force.
To be able to guarantee an equal running life, the load forces reduce, according to the position, on the
working face.
You will find detailed information in the catalogue indications concerning to your cam in the internet
under:
www.strack.de
8
STRACK NORMA GmbH & Co. KG · Königsberger Str. 11 · D-58511 Lüdenscheid · Tel +49 2351 8701-0 · www.strack.de
Attention:
If the cam should be superstructed with accessories
a new calculation is necessary.
Please contact us.
I
Operating instructions -- PowerMax cam unit PMOL
SN5650-PMOL-0230-20°-B-N/Z
33 41 54 68 94 150
35 45 61 78 114 189
38 49 67 90 132 236
39 51 68 100 153 313
39 51 68 98 150 295
38 48 66 88 130 226
35 45 78 111 182
60
17,5
3 x 25 3 x 15
230
94 68 54 41 33
114 78 61 45 35
132 90 67 49 38
153 100 68 51 39
150 98 68 51 39
130 88 66 48 38
111 78 60 45 35
17,5
3 x 25
 F max. = 360 kN
(500.000 Hub)
33
35
38
39
39
38
35