Heating Milk; Preparing Milk Foam; Cleaning & Maintenance - Inventum MK300 Gebrauchsanleitung

or is it not handled in accordance with the instruction
manual, the full responsibility for any consequences will
rest with the user. any damages to the product or other
things are not covered by the warranty.
2 | bEFoRE FIRST USE
Before you use the appliance for the first time, please do
as follows: carefully unpack the appliance and remove all
the packaging material. keep the material (plastic bags and
cardboard) out of reach of children. check the appliance
after unpacking for any visible damage, possible from
transportation. place the appliance on a stable and heat
resistant surface.
clean the lid, the whisk and the mixer with warm soapy
water. Dry the parts thoroughly. Make sure that the parts
are completely dry.
Wipe the exterior and interior with a soft damp cloth and
dry thoroughly. the appliance is only suitable heating and
frothing milk. Never fill the appliance with other drinks.

3 | pREpARING MILK FoAM

check that the voltage in your home corresponds with the
voltage printed on the bottom of the appliance and plug
the appliance in.
lift the lid and fit the whisk in the jug. fill the desired
amount of milk into the jug. Do not exceed the maximum
of the lower max. mark - MaX
expands and causes the pitcher to overflow, if filled up too
high. the minimum capacity is 50 ml.
put the lid back on the jug and place the appliance on the
base. start the preparation by pushing the start button.
the control light will burn and the whisk will start turning.
Depending on the filling volume, the preparation stops
automatically after 60 to 90 seconds. the control light
goes out. after the preparation is completed, remove the
lid upwards and pour or ladle the milk foam into a cup or
bowl.
Do not remove the foam with a spoon or other metal
object. this will damage the coating.
after having used the frother, clean the appliance as
described in the chapter cleaning & Maintenance.
allow the appliance to cool down for 2 to 4 minutes before
using it again.
TIppS
• the best result is achievement when using whole
milk.
• if the amount of milk of too low the result will not be
good - less than 50 ml.
- 100 ml. frothed milk

4 | HEATING MILK

lift the lid and fit the mixer in the jug. fill the desired
amount of milk into the jug. Do not exceed the maximum
of the top max. mark - MaX
put the lid back on the jug and place the appliance on the
base. start the preparation by pushing the start button.
the control light will burn and the mixer will start turning.
Depending on the filling volume, the preparation stops
automatically after 60 to 90 seconds. the control light
goes out.
after the preparation is completed, remove the lid upwards
and pour the hot milk into a cup.after having used the
appliance, clean it as described in the chapter cleaning &
Maintenance.
allow the appliance to cool down for 2 to 4 minutes before
using it again.
5 | CLEANING & MAINTENANCE
Before cleaning always unplug the appliance and let it
cool down completely. clean the appliance immediately
after every use. remove the whisk or the mixer by pulling
it straight upwards. clean the lid, the whisk and the mixer
with warm soapy water. Dry the parts thoroughly. rinse
the inside of the milk frother with hot water. Never use any
aggressive or abrasives cleaning agents or sharp objects
that could damage the coating! Dry with a soft cloth. Make
sure you remove all the milk residue from the inside. it is
not hygienic and can be harmful.
Never immerse the appliance, the power base, the power
cord or plug in water or other liquids. Wipe the outside of
the appliance with a damp cloth regularly.
7
- 250 ml.