Heating Milk; Cleaning & Maintenance - Inventum MK650 Gebrauchsanleitung

After having used the frother, clean the appliance as described
in the chapter Cleaning & Maintenance.
Allow the appliance to cool down for 2 to 4 minutes before using
it again.
TIPPS
• The best result is achievement when using whole
milk.
• If the amount of milk of too low the result will not be
good - less than 50 ml.
5

heating milk

Lift the lid and fit the mixer in the jug. Fill the desired amount of
milk into the jug. Do not exceed the maximum of the top max.
mark - MAX - 250 ml.
Put the lid back on the jug and place the appliance on the base.
Start the preparation by pushing the button
The red control light will burn and the mixer will start turning.
Depending on the filling volume, the preparation stops
automatically after 150 to 170 seconds. The control light goes
out.
After the preparation is completed, remove the lid upwards and
pour the hot milk into a cup. After having used the appliance,
clean it as described in the chapter Cleaning & Maintenance.
Allow the appliance to cool down for 2 to 4 minutes before using
it again.
MK650 - instructions 0314.indd 11
6
Before cleaning always unplug the appliance and let it cool down
completely.
Clean the appliance immediately after every use.
Remove the whisk or the mixer by pulling it straight upwards.
Clean the lid, the whisk and the mixer with warm soapy water.
Dry the parts thoroughly. Rinse the inside of the milk frother with
hot water. Never use any aggressive or abrasives cleaning agents
or sharp objects that could damage the coating! Dry with a soft
cloth. Make sure you remove all the milk residue from the inside.
It is not hygienic and can be harmful.
Never immerse the appliance, the power base, the power
cord or plug in water or other liquids. Wipe the outside of the
appliance with a damp cloth regularly.
.
cleaning & maintenance
11
English •
27-8-2014 12:14:32