Herunterladen Inhalt Inhalt Diese Seite drucken

H-tronic Automatiklader AL 600plus Handbuch Seite 16

Vorschau ausblenden Andere Handbücher für Automatiklader AL 600plus:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

– Cables or leads connecting the device or connecting components within the
device should be examined thoroughly for faults in the insulation.
– If a fault in the cables of the device is found, the device should immediately be
removed from service until the defective cables have been replaced.
If the following manual does not fully describe function and safety precautions
to a layman, or if the technical appliance is not clear, or if it is unclear which
external devices may be attached and how to attach them, then it is vital to
contact a specialist for advice. Before mounting this device and connecting the
accessories, make sure, that this device is suitable for the intended use.
If there is any case of doubt or there are any questions, please contact specialists,
experts or the manufacturers of the modules and components. Please note, that
operating and connection errors are beyond our influence and that we cannot
maintain warranty or be made liable for damages occurring thereof.
This item was tested and manufactured according to EMVG (EG Directive
89/336/EWG/ Electromagnetic Compatibility) and holds the corresponding
CE approval. Any change of the circuitry or exchange of components other
than specified will make this approval invalid.
The device may be used for the described purpose, if these operating
instructions are observed.
– Do not operate the device during frost or danger of frost to avoid the formation
of condensation water.
– Do not expose the device to rain or moisture to avoid a fire hazard and the
danger of an electric shock.
– Do not allow liquids of any kind to penetrate into the device.
– Never cover the ventilation slots or housing.
– Do not place the device near to warm air sources such as heaters or the
like!
– Never put or lead the charging cable near to inflammable materials. The
charging cable may neither be kinked nor be led over sharp-edged parts.
– Live cables or lines, which are connected to the device, must always be tested
before and after use for insulation faults or breakages.
16
AUTOMATIC CHARGER

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

2 24 22 17

Inhaltsverzeichnis