Hama M620 Bedienungsanleitung Seite 6

3. Connecting the mouse / getting started
a) Press the connect button on the receiver; the status LED starts to blink (Fig. 3).
The receiver is now ready to synchronise the mouse automatically.
b) Within 10 seconds, press the connect button with a pointed object (for instance
a pen) on the base of the mouse (Fig. 2). This button is marked with "Connect".
Please note that the mouse should be no more than 30 cm away from the
receiver during this connect phase.
c) The status LED on the receiver lights continuously after the synchronisation
process has been completed successfully. The mouse is now ready for use.
If the cursor does not move then repeat steps 3a-b. This also applies
if interference originating from other radio mice or keyboards occurs during
operation.
Fig.3
4. Battery control lamp
If the voltage level of the batteries drops below the preset value and the mouse is
actuated by movement or clicking, then the battery control lamp will blink (Fig. 1).
The mouse will still function for a while, but you should replace the batteries as
soon as possible.
5. Other Information
· During normal operation, the mouse should be located no more than 90 cm
away from the receiver to ensure a reliable connection.
· When the mouse is activated, the status LED of the receiver illuminates
or fl ashes.
connect button
Status-LED
5