Safety First - Polti VAPORELLA INOX 3000 Handbuch

ENGLISH
IMPORTANT
• All types of textile can be steam ironed with the iron set to COTTON
- LINEN.
• For dry ironing set the iron temperature control (7) to the fabric re-
quired to be ironed.
• During ironing the illuminated switch (2) may occasionally light up.
This is quite normal and you can continue ironing regardless.
• When the iron has used up all the steam in the generator, switch off
the generator switch (2), wait 2-3 minutes, to cool down, then un-
screw the patented safety cap and you can proceed if desired to re-
fill the generator with water.
• During the initial operation of the machine some droplets of conden-
sation will be emitted. It is advisable on each use not to direct the first
jets of steam onto the fabric to be ironed.
• Screw and unscrew the patented safety cap (1) carefully, otherwise
you may experience some escapes of steam from the Cap area whilst
the system is in operation.

SAFETY FIRST

• Do not leave the appliance unattented whilst plugged in.
• Disconnect the iron from the mains when filling or refilling.
• The appliance is provided with a safety thermostat.
Should this need replacement, refer to an authorised electrician.
• If the security cap will not open for refilling, plug in the appliance (4),
switch on the iron (3), and press the steam release switch (8) suc-
cessively until any remaining pressure in the generator has been eli-
minated.
• If replacement of the power supply cable (4) should become neces-
sary, please be sure to consult only a qualified electrician or your Polti
Service Center.
• If the safety cap needs repair or replacement use only genuine ori-
ginal Polti parts.