Request; An Area Subject To High Temperatures Or Exposed To Direct Flame - Mitsubishi Daiya SAF150E6 Anwenderhandbuch

Request

Checking Install Location
This air-to-air heat exchange unit is designed to be used in offces or conference rooms. The main unit
and the room air intake opening (supply/exhaust air grill) cannot be used in the following locations.
An area subject to high
temperatures or exposed to
direct flame
Avoid a location where the temperature in
the vicinity of the air-to-air heat exchange
unit and cassette type louver rises to 40
°C or higher. Using the product in areas
subject to such high temperatures may
cause deformation of a filter or heat
exchange element, or combustion loss of
the motor.
40°C
• For details about install locations and installation, consult your sales representative or
installation service shop.
• If you assume inverse rotation caused by adverse wind, we recommend that you install an
"Electric damper" (to be procured separately) to prevent air from entering.
CAUTION
Intrusion of bugs, etc.
If you want to stop the ventilator to prevent bugs and other insects from entering, be sure to
●
switch the mode to "energy recovery" first, and then turn off the operation switch to stop the
ventilator. Even when you use the ventilator in "normal ventilation" mode, switch the mode to
"energy recovery" first, wait for at least 30 seconds, and then turn off the operation switch to
stop the ventilator. If you stop the ventilator in "normal ventilation" mode, the dampers will not
be switched and bugs and other insects may enter into the room.
In order to suck fresh air into the room, this product is equipped with a rough filter in the
●
air supply portion. However, in an environment containing many bugs or that has light that
attracts bugs and other insects near the outside air openings, the rough filter cannot block
bugs, and they may enter through gaps around the filter and gaps in the main unit.
When fog or humid air is sucked in, dew may form inside the main unit, and dew may leak
●
from the main unit. If this occurs, stop the ventilator.
6
A humid area
Do not use the product in the
bathroom or an area subject high
humidity or where steam is generated.
Doing so may cause dew to form
inside the main unit, resulting in
electric shock or fire, or cause dew to
drop.
A cooking room or other
area containing thick greasy
fumes
Grease may be attached to filters or heat
exchange elements, rendering the product
inoperable.
Greasy
fumes
Room air
intake opening