Filtration Group MFS-E900 Originalbetriebsanleitung Seite 39

13.2 Displaying signal states
 Press
repeatedly until the signal states (time, I, Q or
M) are displayed.
 Mark the required parameter with
 The signal state of the required parameter (time, I, Q or
M) is displayed.
 Press the
key.
 The controller shows the normal operating mode again.
13.3 Displaying the program name
13.3.1 LOGO! Version 0BA6
 Press
repeatedly until the signal states (time, I, Q or
M) are displayed.
 Press the
key.
S t o p
S e t P a r a m
S e t C l o c k
> P r g N a m e
Fig. 15: Marking "Prg Name"
 Press
repeatedly until "Prg Name" is marked.
 Press the
key.
 The program name is displayed.
 Press
twice.
 Press the
key.
 The controller shows the normal operating mode again.
13.3.2 LOGO! Version 0BA8
 Press
repeatedly until the signal states (time, I, Q or
M) are displayed.
 Press the
key.
 Press
repeatedly until "Program" is marked.
S t o p
P r o g r a m
S e t u p
N e t w o r k
D i a g n o s t i c s
Marking "Program"
Fig. 16:
 Press the
key.
 Press the
key.
S e t P a r a m e t e r
P r o g N a m e
Marking "Program"
Fig. 17:
 Press the
key.
 The program name is displayed.
 Press
twice.
 Press the
key.
 The controller shows the normal operating mode again.
Translation of the original instructions MFS-E900, Filtration Group GmbH, 26.09.19, Mat. No. 72370026, Version 05
and .




13.4 Replacing the program module
Do not attempt to remove the program module while
the unit is operating!
 Risk of damage to the system or injury to persons as a
result of malfunctions.
 Always switch off the E900 prior to replacing the
program module!
Fig. 18: Replacing the program module
 Switch off the E900.
 Carefully lever out the program module with a
screwdriver.
 Remove the program module.
 Insert a new program module so that it latches audibly.
13.5 Displays
P 1 5 . 8 2
P 2 5 . 8 1 b
D P 0 . 0 1 a
S P 0 . 7 0 r
Fig. 19: Status displays P1, P2
P 3 0 . 0 3
S P 0 . 7 0
b a r
Fig. 20: Status display P3
 Press ESC +
or
ESC + to change the switching point.
 Press ESC+
to change the pressure display (condition:
B24 = ON, i.e. with secondary filter).
CAUTION!
Page 11