Herunterladen Inhalt Inhalt Diese Seite drucken

English; User Instructions; General Information - Mission m3i Serie Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

m3i manual 05-07-04.qxd
08/07/2004
09:46
Page 2

English

Cautions
Before installing this product read all these instructions.
Clean only with dry cloth.
When making any connections, switch the amplifier off.
When you switch on your system or change sources, set the
volume control at minimum and turn the level up gradually.
DO NOT use your amplifier at full volume.
Avoid extreme settings of tone controls or graphic equalisers.
Ideally, they should be set 'flat' or, if possible, bypassed. Ensure
that all loudspeakers in the system are correctly wired and are
in phase.
DO NOT subject your loudspeakers to excessive cold, heat,
humidity or sunlight.
DO NOT install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers) that
produce heat.
DO NOT place heavy objects on top of loudspeaker cabinets.
m
as
3
important safety instructions
DO NOT block any ventilation openings.
DO NOT defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades with
one wider than the other. A grounding type plug has two
blades and a third grounding prong. The wide blade or the
third prong are provided for your safety. If the provided plug
does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
WARNING: If using spikes make sure that they do not pierce
mains cable etc. under/above the carpet.
Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
WARNING: To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture.
Warranty
The warranty card enclosed should be completed and
returned to Mission or its Distributor within 8 days of purchase.
Conditions
No Dealer or Distributor may vary the terms of this warranty
which is personal to the original purchaser and is not
transferable.
Please retain the sales receipt as proof of purchase.
Warranty claims must wherever possible be made through the
Dealer from whom the equipment was purchased.
This warranty excludes:
Damage caused through neglect, accident, misuse, wear and
tear, or through incorrect installation, adjustment or repair by
2
DO NOT connect your loudspeakers to the mains supply,
except for subwoofers.
DO NOT attempt to dismantle the loudspeaker. There are no user
serviceable parts inside and you will render the warranty void.
Site hi-fi electronics away from the loudspeakers on a rigid
stand or cabinet.
Loudspeakers should not be placed directly facing other hi-fi
units, or share the same shelf or cabinet.
Site conventional speakers and subwoofers at least 0.5m
away from TV sets, computers etc. Some manufacturers forbid
the placing of objects on top of their TV sets. Check your TV
handbook before installing the centre speaker directly on your
TV set. Consult your TV dealer if you are in any doubt.
Only use attachments/accessories specified by the manufacturer.
Use only with the cart, stand, tripod, bracket, or table specified
by the manufacturer, or sold with the apparatus. When a cart
is used, use caution when moving the cart/apparatus
combination to avoid injury from tip-over.
DO NOT use this apparatus near water.
The apparatus must not be exposed to dripping or splashing
and no objects filled with liquids, such as vases, should be
placed on the apparatus. Unplug this apparatus during
lightning storms or when unused for long periods of time.
Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way,
such as power-supply cord or plug is damaged, liquid has
been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
When this symbol is shown there is a risk of electrical
shock.
When this symbol is shown extreme caution should
be observed.
unauthorised personnel. Any unauthorised servicing will result
in loss of warranty.
Liability for damage or loss occurring in transit to or from the
purchaser.
Consequent damage, loss or injury, arising from or in
conjunction with this equipment.
Equipment for attention under warranty should be considered
return carriage paid. If equipment is found to comply with the
published specification, Mission reserves the right to raise a
charge.
The above conditions do not affect your statutory rights as a
consumer.

User Instructions

i
Welcome to Mission
The m3
series is the latest in a long line of distinguished Mission loudspeakers.
These technologically advanced loudspeakers will complement the finest
electronics and decor. Bass drivers using DiaDrive cones with pressure balanced,
ventilated spiders and advanced Viotex laser trimmed pressure balanced tweeters
are used throughout the range. High purity gold-plated binding posts feature on
all models. Your Mission m3
for many years.

General Information

Please read these instructions carefully before installing your loudspeakers.
A few minutes studying this manual will ensure superb performance from your
loudspeaker for many years.
Please pay attention to all cautions printed on the pages marked with
this symbol.
Unpacking Your
· Carefully unpack each loudspeaker.
· Retain all the packing materials so that your loudspeaker can be repacked and
Loudspeakers
shipped without damage.
· To ensure that your loudspeakers are protected during transportation, a protective
film has been inserted between the grille and the cabinet. Before using your
loudspeakers please remove the protective film by gently pulling the grille away
from the cabinet and discarding the film.
Fitting Spikes
Warning: Be careful. Loudspeaker spikes are very sharp. When
positioning the speakers avoid piercing any electrical cables.
m
m
m
i
i
i
33
,
34
,
35
· Invert the loudspeaker and place the top on a soft surface.
· Screw a nut on each spike.
· Screw the spikes into the bushes fitted in the base of
the cabinet. Use the sharp end on carpet, or the
domed end on hard floors.
· Carefully return the loudspeaker to its
normal position.
· Ensure that spikes do not pierce cables
etc. under the carpet.
· Adjust the height by screwing in or out
one or more of the spikes until the
loudspeaker is stable and level.
i
loudspeakers will bring you great listening pleasure
3

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis