Herunterladen Inhalt Inhalt Diese Seite drucken

Installation; General Information; Prior To Installation; Required Installation Material And Auxiliary Equipment - Hydropa DS-4 7 Serie Anleitung

Druckschalter
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Operating Manual / Piston Pressure Switch

6 Installation

6.1 General information

DANGER of injury and material and environmental damage
It is imperative that the safety instructions in chapter "
observed.

6.2 Prior to installation

Extreme cleanliness should be ensured, as dirt leads to malfunctions and can impair the reliable
function of the components.
Conduct a visual inspection for any transportation damage and dirt.
6.2.1

Required installation material and auxiliary equipment

Fixing hole
(diameter in mm)
Ø5.5
1)
A torque spanner with a tolerance ≤10% should be used for tightening. The specified tightening torques can
be understood as extremely rough and non-binding reference values. See VDI 2230 for the calculation of the
tightening torque. Coefficient of friction µ
6.2.2

Required tools

Only commercially available tools and torque spanners are required to install the pressure switch.

6.3 Installing the pressure switch

DANGER of injury and material damage
The relevant plant part should always be relieved of pressure and de-energized
prior to installing/dismantling the pressure switch.
Use of the pressure switch is only permitted in plants in which the max. operating
pressure Pmax is not exceeded (see technical data or rating plate).
WARNING of risk of injury and material damage
Exceeding of the max. operating pressure Pmax through pressure peaks and
pressure surges and the exceeding of temperature limit values lead to
consequences ranging from behavioural changes to damage.
NOTE
The pressure switch should be installed in a low vibration environment and
protected against pressure surges to increase the service life.
All dimensions relevant to installation and other information can be found in the
technical data for the respective pressure switch.
10
Hexagonal screws
pursuant to DIN 933 (A2 –
70)
M5
= 0.14 lightly oiled.
total
" on page 4 are
2
Safety
X
X
X
X
Number
Maximum tightening
torque in Nm
4/2
4.2
BA-KDS/GB/2010-REV1
1)

Werbung

Kapitel

Inhaltsverzeichnis
loading

Verwandte Produkte für Hydropa DS-4 7 Serie

Inhaltsverzeichnis