B&R Industries ACOPOSinverter P74-Serie Anwenderhandbuch Seite 373

Various messages may appear when the download is requested:
• [TRANSFER IN PROGRESS]
• [DONE]
• Error messages if download not possible
• [Motor parameters are NOT COMPATIBLE. Do you want to
possible, but the parameters will be restricted
DOWNLOAD GROUP
[None]:
[All]:
[Drive configuration]:
[Motor parameters]: [Rated motor
[Rated motor
[PSI align curr.
[Rated motor
[Motor 1 Cosinus
[Rated motor
[Motor param
[Tune selection](StUn)
[Mot. therm.
[IR compensation](UFr)
[Slip compensation](SLP)
[Cust stator
[Lfw](LFA)
[Cust. rotor t
[Nominal I
[Nom motor
[Pole pairs](PPnS)
[Syn. EMF
[Autotune L
[Autotune L
[Nominal freq
[Cust. stator R
[Motor torque](tqS)
[U1](U1)
[F1](F1)
[U2](U2)
[F2](F2)
[U3](U3)
[F3](F3)
[U4](U4)
[F4](F4)
[U5](U5)
[F5](F5)
The motor parameters that can be accessed in
[Mot. therm.
[Communication]:
ACOPOSinverter P74ACOPOSinverter P74New Anwenderhandbuch 2.60 Übersetzung der Originalbetriebsanleitung
volt.](UnS)
freq.](FrS)
max](NCr)
speed](nSP)
phi](COS)
power](nPr)
choice](MPC)
current](ItH)
resist.](rSA)
const.](trA)
sync.](nCrS)
spdsync](nSPS)
constant](PHS)
d-axis](LdS)
q-axis](LqS)
sync.](FrSS)
syn](rSAS)
current](ItH)
continue?]: In this case, the download is
No parameters
All parameters in all menus
The entire
In the [MOTOR
[Expert](EPr) mode
In the [SETTINGS](SEt-)
All the parameters in the
Programming
[1 DRIVE MENU] [COMMUNICATION]
without
CONTROL](drC-) menu
menu
[COMMUNICATION]
menu
373