Overview; Factory Configuration - B&R Industries ACOPOSinverter P74-Serie Anwenderhandbuch

3.1.2 Overview

3.1.2.1 Factory configuration

The ACOPOSinverter P74 is factory-set for common operating conditions:
• Display: drive ready
• The LI3 to LI6 logic inputs, AI2 and AI3 analog inputs, LO1 logic output, AO1 analog output and R2 relay
are unassigned.
• Stop mode when fault detected: freewheel.
Hinweis:
Um die Nutzung der POWERLINK Einschubkarte zu erleichtern, wird nach dem ersten Start die aktu-
elle Einstellung der POWERLINK Knotennummer angezeigt. Um aus diesem Untermenü heraus zum
aktuellen Status zu gelangen, muss der Knopf "ESC" mehrfach betätigt werden.
Code Description
bFr [Standard mot. freq]
tCC [2/3 wire control]
Ctt [Motor control type]
[Acceleration]
ACC
dEC [Deceleration]
LSP [Low speed]
HSP [High speed]
ItH [Mot. therm. current]
SdC1 [Auto DC inj. level 1]
[Switching freq.]
SFr
Frd [Forward]
rrS [Reverse assign.]
Fr1 [Ref.1 channel]
r1 [R1 Assignment]
[Dec ramp adapt.]
brA
Atr [Automatic restart]
Stt [Type of stop]
CFG [Macro configuration]
Hinweis:
If you want to keep the drive presettings to a minimum, select the macro configuration
[Macro configuration](CFG)
Check whether the values above are compatible with the application.
ACOPOSinverter P74ACOPOSinverter P74New Anwenderhandbuch 2.60 Übersetzung der Originalbetriebsanleitung
[Ready](rdY) when motor is ready to run and motor frequency when motor is running.
Factory settings values
[50Hz IEC]
[2 wire](2C): 2-wire control
[Standard](Std): standard motor law
3 seconds
3 seconds
0 Hz
50 Hz
Nominal motor current (value depending on drive rating)
0.7 x nominal drive current for 0.5 seconds
4 kHz
[LI1](LI1): Logic input LI1
[LI2](LI2): Logic input LI2
[AI1](AI1): Analog input AI1
[No drive flt](FLt): The contact opens when a fault is detected or when the drive has been switched off
[Yes](YES): Function active (automatic adaptation of deceleration ramp)
[No](nO): Function inactive
[Ramp stop](rMP): On ramp
[Start/Stop](StS)
= [Start/stop](StS) followed by [Restore config.](FCS)
Programming
= [Config. CFG](InI).
117