Installation; Pipe Dimensions; Checking The Wall; Preparing The Installation - Viva VVA96E650 Gebrauchs- Und Montageanleitung

Installation

Pipe dimensions

Note: The device manufacturer does not assume any warranty
for complaints attributable to the pipe section.
The device achieves its optimum performance by means of a
■
short, straight exhaust air pipe and as large a pipe diameter
as possible.
Because of long rough exhaust air pipes, many of which are
■
pipe bends or have diameters smaller than 150 mm, the
optimum extraction performance is not achieved and fan
noise is increased.
The pipes or hoses for laying the exhaust air line must
■
consist of non-combustible material.
Round pipes
An inner diameter of 150 mm, but at least 120 mm, is
recommended.
Flat ducts
The inner cross-section must correspond to the diameter of the
round pipes.
Ø 150 mm approx. 177 cm
Ø 120 mm approx. 113 cm
Flat ducts should have no sharp deflections.
■
Use sealing strip for deviating pipe diameters.
■

Checking the wall

The wall must be level, vertical and adequately load-bearing.
■
The depth of the bore holes must be the same length as the
■
screws. The wall plugs must have a secure grip.
The enclosed screws and wall plugs are suitable for solid
■
brickwork. Suitable fasteners must be used for other
structures (e.g. plasterboard, porous concrete, poroton
bricks).
The max. weight of the extractor hood is 40 kg.
■
2
2

Preparing the installation

Mark a vertical centre line on the wall from the ceiling
1.
to the lower edge of the extractor hood.
Mark positions for the screws and the contour
2.
of the attachment area.
Drill five 8 mm Ø holes to a depth of 80 mm
3.
for the attachments and press in the wall plugs flush with
the wall.
 PP
PLQ  PP
PD[  PP
  PP
 PP
Installation
Screw on the fixing bracket for the flue duct.
1.
$
 PP
 PP
[
¨
[
17