Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation
1. Connect the power supply, and the indicator will be bright, rotate the left chain network speed adjustable
knob "COLOUR CONTROL" to the position of "3"(Note: the lighter of the color, the faster of the chain
network speed).Rotate the right switch knob to the position of "BREAD", then the heating pipes of the
upper and down layers will heat up at the same time, and the temperature in the furnace will go up
gradually. When there is no toast in the furnace, the temperature inside can reach 284°C within 12 minutes,
later it can maintain constant temperature of 284°C.
2. Before baking, Connect power and preheat about 10-12 minutes, then have a try of two pieces of toast,
and adjust the speed of the chain network according the color of the toast. If you want a deeper color,
rotate adjustable knob "COLOUR CONTROL" clockwise after the position of "3". When the speed of the
chain is ready, then put the toast on to the guiding network, then the toast will be take into the furnace to
bake.
3. When the toast is finished, it will be turned onto the under-plate, then slip from the under-plate to the
front of the furnace. The sketch is as following:
The
after
slide
hanging here
4. If you want to take the toast in the back, there is a after-plate, only press the after slide plate with ear pull,
to lead the front of the after-slide-plate along the hooks in the side of the chain wheel. The finished toast
will slip to the after plate along with after-slide-plate (following sketch) .After operation, you can reset the
after-slide-plate with the ear pull.
5.
6. When baking buns, rotate the right adjustable knob to the position of "BUNS", only the upper heating pipe
works at this time. If you need to keep warm, rotate the knob to position"STBY".
7. After finishing, rotate the knob to position "OFF", and Unplug.
8. If the power soft wire is broken, please change it with a specific wire and specific components, please ask
professional person to do the job.
plate
is
Put the after-slide-plate here.
后滑道板放到此位置
Werbung
Inhaltsverzeichnis
