Kidwell ALULA 5901130080298 Benutzerhandbuch Seite 19

USE
4
Opening the window – unzip the window and carefully pull the material away at the
ends to see the frame.
Next, press the button which is located on the window bar in the direction of the inside
of the window and hold it in that position simultaneously removing the window bar by
gently pulling upwards. Repeat the same steps on the second side of the window bar.
As soon as the window is opened, secure it to prevent unfolding by using the elastic
loops attached.
WARNING: When, the crib bed is not placed alongside the adult's bed and not
secured using the straps, crib bed window should remain closed.
WARNING: Before placing a child in the crib bed, make sure that the locks in all 4
wheels are activated.
5
Height Adjustment – in order to adjust the height of the crib bed, simultaneously pull
the handles upwards which are located at the top of the crib bed legs. You can adjust
the height to 5 positions.
For child's greater comfort, you can also recline the bed to a desired position on only
one of the sides of the crib bed.
WARNING: Before placing the child into the crib bed, make sure that the height lock
is activated.
WARNING: When adjusted in accordance with the manufacturer instructions. The
angle of inclination of the crib base end to end (head to feet) shall not be greater than
10° to the horizontal and it shall be capable of providing a horizontal sleeping position
(0° ± 2°).
6
In order to properly attach the crib bed to adult's bed, fi rst check the height of the crib
bed and adjust it to the height of the mattress/adult's bed. The crib bed should be
tightly placed alongside the adult's bed leaving no gaps, the telescopic base enables
to adjust the crib bed also to low bed frames. When the crib bed is placed alongside
the adult's bed, activate the locks on all 4 wheels.
In order to attach the two beds, use the strap included in the set. One part of the strap
should be connected to a side release buckle which is located on the crib bed legs.
Wrap the strap around the adult's bed frame and connect the other end of the strap to
the side release buckle located on the other crib bed leg.
The strap should be fi xed tightly to the bed frame. The length of the strap can be
adjusted by using the tri-glide slide located on the strap.
WARNING: The height diff erence between the crib bed and the adult's bed can be 2
cm at most.
WARNING: Each time prior to using the crib bed, make sure that the crib bed is
attached according to the manual and there are no gaps between the bed/mattress of
the adults and the side wall of the crib bed. When using the product as a crib bed on its
own, always make sure that the side wall of the crib bed is fi xed in an upright position
and closed. Do not leave the child unattended in the crib bed with the side wall down.
19