Installation; Commissioning - auna Simpfy Handbuch

INSTALLATION

• Unpack all parts and remove protective material.
• Do not connect the unit to the mains before checking the mains voltage
and before all other connections have been made.
• Do not cover any vents and make sure that there is a minimum distance
of 10 cm around the unit for ventilation.

COMMISSIONING

Initial Use
• Before operation, please make sure that the VOLTAGE mentioned on
the power supply is same as the voltage of your local area. Use the
supplied mains adaptor to connect the device to a household mains
socket.
• Switch the device on with the power switch on the rear.
• When it is the first time running the device, the setup wizard is launched
automatically.
• Press Standby button
mode. Press again will make it on again.
Setup wizard
When radio is started for the first time, it runs through a setup wizard to
configure settings for date/time and network. Once this has finished, the
system is ready to use in most modes.
NOTE: To change these settings later, select Menu>System settings>and
select the required settings options. To run the setup wizard again, select
Menu>System settings>Setup wizard
The Setup wizard guides you through the basic setup parameters for Time/
Date and Network connection. To change any settings later all setting
functions are accessible from the Settings Menu.

when unit is power on, unit will go to standby
EN
43