Routine Maintenance - Cembre B1300TEP Bedienungsanleitung

3.3) Flexible hose
Operate the tool with the hose uncoiled. Do not bend, twist, kink, knot or squash the hose. Before
operation, check the hose for any sign of damage.
When storing the tool in the trolley, coil the hose in large loops.
High pressure flexible hoses are subject to a natural ageing process which can result in
a reduction of performance and safety of the operator, as a result their life span is
limited.
Cembre therefore recommends the replacement of the hose within 10 years from the date
printed on the hose.

3.4) Routine maintenance

When the pump reaches the predetermined number of hours worked, it will signal that routine
maintenance is recommended.
The pump will continue to work however 15 sec. after use an alarm comprising 3 beeps
combined with illumination of the worklights will signal that its return to Cembre for over-
haul is recommended (see § 4).
3.5) Replacement of the automatic coupler
To replace the automatic coupler proceed as follows:
Remove the old coupler.
Carefully clean the thread of the cup to remove the old sealant.
Apply tefl on tape to the thread.
Fit the new automatic coupler and tighten to 30 Nm (22 lbf ft).
4. RETURN TO Cembre FOR OVERHAUL
In the case of a breakdown contact our Area Agent who will advise you on the problem and give
you the necessary instructions on how to dispatch the tool to our nearest service Centre; if possible,
attach a copy of the Test Certifi cate supplied by Cembre together with the tool or fi ll in and attach
the form available in the "ASSISTANCE" section of the Cembre website.
Following information applies in member states of the European Union:
USER INFORMATION in accordance with Directives 2011/65/EU and 2012/19/EU.
The "Not in the bin" symbol above when shown on equipment or packaging means that the equipment
must, at the end of its life, be disposed of separately from other waste.
The separate waste collection of such equipment is organised and managed by the manufacturer.
Users wishing to dispose of such equipment must contact the manufacturer and follow the prescribed
guidelines for its separate collection. Appropriate waste separation, collection, environmentally compat-
ible treatment and disposal is intended to reduce harmful environmental eff ects and promote the reuse
and recycling of materials contained in the equipment. Unlawful disposal of such equipment will be sub-
ject to the application of administrative sanctions provided by current legislation.
6
12