Werbung
Verfügbare Sprachen
Verfügbare Sprachen
z
accessoires
Congratulation on your purchase of your new z Series Adapter.
IMPORTANT: Before installation of your High Low Converter, we recommend to read the owner´s manual
carefully and to follow the instructions regarding connection and fitting exactly.
ATTENTION: Pay attention to advices and instructions of the car manufacturer.
Important: Your proof of purchase is evidence of warranty claim for repair or replacement. Keep your proof
of purchase, manual and original packaging.
ATTENTION: Use of sound components can impair your ability to hear necessary traffic sounds and may
constitute a hazard while driving your automobile.
Audio System Germany accepts no liability for hearing loss, bodily injury or property
damage as a result of use or misuse of our products.
We recommend installing the equipment by an authorized service center or dealer. A professional fitting
and connection is the requirement for further warranty and perfect sound.
hlc 2 em
- 2-Channel High-Low-Adapter
- Connectable to OEM-amplifiers up to 60 W RMS by HPI-technology
- Prohibit disturb signal and power up noise
- Generate a turn-on signal(Remote) over BTL or Signal Recognation (SE-circuit)
- Integrated turn off for Signal Detect (SE)
- Outstanding sound quality
- 5-Volt preamplifier technology (RCA couplings)
- Open wire ends with fast clip connectors for easy install
- Very fast and correct music recognition (SE and BTL-technology)
- Advanced speaker load simulation with forward-looking PRS-circuit
Please follow the instructions during the installation of your High-Low-Adapter:
a) Take care of a professional attachement. Pay attention, that no electrical cable, gas tank, hydraulic breakes
or other components get damaged.
b) Protect your HLC 2 Em from fluids, wetness, heat and foreign material as well as from other influences.
c) The High-Low Adapter is only to be built into vehicles with a 12 V DC power supply.
d) Never install the power supply cable with other original wires of the vehicle (gas cables), fan motors, brand
control moduls etc.
e) Install the signal cable (cinch cable) as well as the speaker cable far away of the power cables to avoid
troubles with the music signal.
g) The cables of your HLC 2 Em have to be installed, so that there is no danger of binding, squeezing
or breaking.
features
ATTENTION
2
Werbung
