Charging The Battery - Mellerware Tidy! Random Gebrauchsanweisung

SIDE BRUSHES INSTALLATION
Mount the side brushes on the
bottom of the robot by pressing the
brushes into its slot.

CHARGING THE BATTERY

Warning: A new battery does not
–
come with a full charge and must
be fully charged before using the
Charge the battery at an
–
atmospheric temperature of
between 4 and 40˚C.
Turn on the ON/OFF button located
–
on the bottom of the robot.
Put the robot in the charging base
–
and ensure that the automatic
charging poles are aligned
correctly.
The charging indicator light (F) will
–
blink in red color. When the LED
stops blinking the robot is loaded.
Load the robot for 4 hours before
–
Instructions for use
START CLEANING
Before starting use, ensure that the
–
power switch (L) is on.
You can turn on the robot in several
–
(C), the start/stop button (4) or the
AUTO cleaning mode button (1) on
the remote control.
NOTE: If the battery is about to
–
run out, the robot will return to the
charging base automatically to
recharge.
NOTE: If the load base is
–
inaccessible, the robot can not
be recharged, it will return to the
initial situation and the cleaning
system will end. In this case, place
EN