Display Positioning - Samoa 366760 Handbuch

Change the batteries, proceed as follows:
1. Press RESET to update all the totals.
2. Loosen the 4 fixing screws of the lower
cover.
3. Remove the old batteries.
4. Place the new batteries in the same
position as the old ones.
5. Close the cover again, by positioning the
rubber protection as a gasket.
6. Meter will switch on automatically and
normal operation can be resumed.
The square shape of the meter body allows
the card to be rotated in its housing, thus
ensuring great versatility in positioning.
This allows easy
position. The card housing is closed by a
plastic cover sealed through a rubber
protection acting as a gasket as well. This can
be easily removed unscrewing the 4 screws
that fix both the cover and the card (1).
8
836 828 R. 10/12
Samoa Industrial, S.A. · Box 103 Alto Pumarín · 33211 Gijón - Asturias Spain · Tel.: +34 985 381 488 · Fax.: + 34 985 384 163
Replacement battery

Display positioning

display readings in any
Maintenance
The meter will display the same Reset Total,
the same Total and the same Partial indicated
before the batteries were changed.
After changing the batteries, the meter does
not need calibrating again.
w
hile fixinG the meter card
the battery contact cable is not placed
above the circular housinG of the bulb
ATTENTION
,
make sure
.