Time Setting - THOMSON WM40i Benutzerhandbuch

USING
INSTALLATION (See pictures below)
The device can be installed:
• Either on a stand (15), put the hooks from the base in
the central cavity at the back of the device. Check that
the base does not come off. To remove the base, pull it
downwards.
• Either the wall using 2 screws and 2 plugs (supplied)
attached so there have about 6.5 mm gap between the
screw heads and the wall. Hang the unit by two holes
(16) on the back.
16
Mains power supply
• Connect the cable socket to the plug (17).
• Connect the other end of this cable to a socket.
• Press q to switch on the device.
Note: To use each function of the device, make sure it is
running.
EN 16
WALL MOUNT MICRO SYSTEM
WM40i

TIME SETTING

In standby mode:
• Press and hold PROG/MEM/C-ADJ.
• Press 7 or 8 to switch to 24H or 12H mode.
• Press again PROG/MEM/C-ADJ to validate: The time
display flashes.
• Set the time with 7 or 8.
• Press PROG/MEM/C-ADJ to validate, the minutes
display flashes.
PROGRAMMING THE TURNING ON /OFF OF THE DEVICE
In standby mode:
• Press and hold TIMER: the symbol "
on the VFD screen and the time display flashes.
• Press 7 or 8 to set the time, then TIMER to confirm
and then set the minutes.
• The symbol "
shut down.
Note: Use the same setting process as the one for
turning on.
• Press TIMER again: "CD" comes up on the screen.
• Press 7 or 8 to select the desired mode when
powering up: TUNER, iPod, CD or BUZZER.
15
• Press TIMER again to set the volume, except if you
select the BUZZER mode.
• Press 7 or 8 to set the volume, then TIMER to
confirm.
• Press TIMER again, the information that you have just
defined appear on the VFD screen.
• Press TIMER to cancel the programming:
the « » signal disappears.
USING THE CD PLAYER
Note: Before using the appliance for the first time, remove
the cardboard protecting the lens located inside the CD
compartment (13).
Playing a CD:
• Press FUNCTION to select the «CD» mode.
• Set the volume with VOL+/ VOL-.
• Open the CD compartment by pressing
CD (label side towards you).
• Close the CD compartment by pressing again
Selection of the tracks:
• Press 7 or 8 to go to the previous or next track. The
track number will appear on the screen.
• Press and hold 7 or 8 to go fast forwards or
backwards. Disk playback resumes when you release
the keys.
Pause and playback mode
• Press 12 to pause the player. Press again to resume
playback.
ON" comes up
OFF" comes up. Set the time of the
then insert a
.