Quickjack BL-5000SLX Schnellstartanleitung Seite 2

DO NOT RAISE QUICKJACK FRAMES WITHOUT
WEIGHT ON THEM. QuickJack Frames are
designed and engineered to be used with the weight of
a Vehicle on them. You should only raise
the QuickJack Frames with the weight of a Vehicle on
them, even the very fi rst time you use
them. QuickJack Frames can occasionally get stuck in a
raised position if you raise them without the
weight of a Vehicle.
DO NOT TRY TO RAISE A LOAD AT NO NET RISE. Your
QuickJack requires some space between the
ground and your Vehicle to build up enough pressure to
raise a load. It cannot raise a full load from
a completely fl at starting position.
DO NOT REMOVE YOUR VEHICLE'S TIRES THEN
LOWER THE QUICKJACK TO THE GROUND.
Your two QuickJack Frames are similar, but they are not
interchangeable. Always
line up your Frames as PARALLEL to each other as the
Lifting Points will allow, with the
Lock Bars on the outside, as shown below.
ALWAYS LOWER THE QUICKJACK IN TO THE LOCKING
POSITION BEFORE WORKING ON A VEHICLE.
Visually confi rm that both QuickJack Frames are on the
same locking positions.
If you have a Reservoir Cap with a Breather Valve, you
must loosen it about half a turn counterclockwise before
using the Power Unit. If you do not, the excess pressure
could damage the pump or cause the Fluid Reservoir to
overfl ow. If you have a self-venting cap, you don't have
to do this.
Self Venting valve | Manual venting valve