Before Startup - Feel-Maestro MR250 Bedienungsanleitung

the appliance.
- Do not place or store appliance where it can fall or be pulled into a
bath or sink.
- Do not use while bathing or in a shower.
- Never drop or insert any object into any opening on this appliance.
ATTENTION!
Be careful because the heated surfaces become very hot during
operation.
Do not touch the heating elements to avoid burns, do not keep the
device near your temples. Let the device cool down after switching
off.
In case of failure to observe the above rules there arises a
danger of receiving burns!
- Hair sprays and fixers contain inflammable components. Do not
use them when the device is ON. Do not direct sprays of any kind or
water on the device.
- Dry your hair before using the device.
THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY. DO NOT
USE THE APPLIANCE FOR ANYTHING OTHER THAN INTENDED
USE.
- Do not use it for commercial purpose.
Actions in extreme situations
- If your device has fallen into water or water has penetrated it,
immediately disconnect it from the mains without contacting the
device itself or the water.
- If there appears smoke, sparkling, strong smell of burning
6
isolation, immediately stop using the device, disconnect
the device from the mains and apply to the nearest service
center.
Operation

Before startup

- Remove all wrap materials and stickers
- Make sure that all the parts of appliance don't have damages.
- Unwind the power cord completely.
- Place the device on a flat dry heatproof surface.
- Connect the device to the mains.
The hair must be clean, dry and brushed.
ATTENTION! A small quantity of smoke or a specific smell may
appear after the first switching ON as the result of conservation
materials contact with heating element. This is a normal
phenomenon and it shall disappear after several minutes of
operation.
- Select a set of replaceable attachments (1/Fig.1) according to
styling. The set includes attachments for straightening and for
making curly hair "gaufre" of various widths.
- Press the retainer (2 /Fig. 1) to remove the attachment and push
it forward on both sides of the tongs. Use in succession the set of
attachments selected by pushing the attachment to the handle till
the retainer clicks.
- To switch the device ON set the switch (3/Fig.1) forward to the
position «ON», the light indicator will flash (4/Fig.1) and the device
will start warming up. Wait till the tongs become heated. Required
temperature will be reached in 3 minutes approximately.
EN
7