Overview Of Displayed Information; Basic Display Functions - GPO RANGEGUIDE 2800 Gebrauchshinweis / Garantie

Overview of displayed information

Binoculars Target marker
Best / Last Target
88888
BEST
LAST
88888
HR
Horizontal distance
(HR)
Angle in Degrees
Number display for HR / angle / temperature
The red OLED target marker always lights up when active.
The first line of the display always shows the direct
distance in meters (M) or yards (Y).
You can choose whether the second line of the output
displays the measured values for the horizontal distance
(in meters or yards), the angle (in + / - degrees) or the
temperature (in degrees Celsius or degrees Fahrenheit).
Direct disctance
(LOS) with units
(meter / yard)
M
Y
°
M F
Y C
Temperature in deg
Celsius / Fahrenheit
Units of HR (meter / yard)
50 50

Basic display functions

(Brightness, Meter/Yard, °C/°F, BEST/LAST)
To change the basic display options, switch the instrument
on by pressing the measurement button and briefly (< 2
sec) press the menu button within the standby time of 15
seconds.
The brightness display will then flash LEV 4. You can
increase the brightness with the measurement button
continuously up to level 9 and then again from 1 to 9.
Confirm the brightness adjustment with the Menu button
and proceed to the Meter / Yard selection.
Now the unit M or Y to be selected will flash. Select either
M or Y using the measurement button . Confirm by
pressing the menu button to proceed to the temperature
selection.
Now the unit °C or °F to be selected will flash instead.
Press the measurement button
either °C or °F. Confirm by pressing the menu button .
Finally, you will reach the BEST/LAST target selection.
Again, the BEST or LAST setting to be selected will flash.
Please use the measurement button
appropriate setting and confirm using the menu button .
Once you have completed these 4 options, you have
configured your RANGEGUIDE 2800. Adjustments should
then only be made to the brightness in the basic settings.
However, you can change the 4 options selected here at
any time by following the procedure described above
again. For details on the settings, see the following pages.
51 51
M
M
to advance and select
M
to select the
M
M
EN IT