Operation - MD MD300 Bedienungsanleitung

Insert the battery into the slots of the charger and slide it into place until it lockes.
There are 2 lights on the charger indicating the status and state of charge of the
battery (Illustration 10):
•
Constant red light: Battery is
charging
•
Constant green light:
1. The charger is ready to charge,
but no battery is connected;
2. The battery is fully charged and should be removed from the charger.
The charger will stop, when the battery is full.
However, it is not recommende to leave the battery in charger for more than 24 hours.
It is recommende to drain the battery completely and fully charge it whenever possible,
as it can increase the health of the battery. But partial charge will not damage the
battery.
To remove the battery from the charger, hold the button down and pull the battery out.
During winter storage, the battery shold be partly charges and kept warm at 10-20
degrees C. Make sure to keep ventilation holes clean and free from dirt.

8. Operation

Safety key
The motor unit has a safety key, which is placed under the battery cover. If the safety
key is removed, the power is disconnected, and it cannot start. (See illustration 11)
It is always recommended to remove the safety key:
•
When the lawn mower is left unattended (to
prevent uninteded start, e.g. by minors)
• Before clearning and maintenance
• Before remove grass blockings
Inserting the battery
Charging the battery as described in the user manual of the charger.
• Open the battery cover. Press the charged battery into the power tool until it clicks
into place.
• Close the battery cover.
Illustration 10
24
Illustration 11