Supra BLIZ’R 3500 Bedienungsanleitung Seite 15

fitted.
- The appliance should be used with its wheels
attached.
ASSEMBLY OF THE EXHAUST HOSE
- Lengthen one head of the hose, and spin the
exhaust hose into exhaust connector (counter-
clockwise).
- Caution: Exhaust pipe is 40 cm~160 cm long
(including adapter).
- The length of exhaust pipe is especially desig-
ned in accordance with the specification of the
air conditioner. Please do not use other exhaust
pipes of different lengths or materials, in such
way failure may be caused.
INSTALLATION OF WINDOW KIT (Fig 3)
- Partially open the window and then fix the win-
dow kit to the window.
- The window kit can be installed on most of
normal and vertical windows and it is adjustable.
- Fix the other end of the heatexhausted hose to
the airoutlet window kit.
INSTRUCTIONS FOR USE
USE:
- Unroll the cable completely before plugging it in.
- Connect the appliance to the mains.
- Press the ON/OFF button, the unit will enter in
cooling mode with low fan speed.
- Press the mode button to select cooling dehumi-
difying, fan mode.
FAN SPEED
- Under the cooling and the fan mode, the speed
goes as follow:
- Lower Fan→Mid Fan→ High Fan.
- In Humidifier mode, the fan only works at low
speed.
TIMER MODE
- In standby mode, press time button to set time
start. Press the up and down button to the time
of start (0~24 hours), and time indicator light is
on.
- In startup mode, press time button to set time
switchoff.
- Press the up and down button to the time of
switchoff (0~24 hours), and time indicator light
is on.
SWING
- Press this button to control the movement of the
louver.
COOLING MODE:
- Press mode to select cooling mode, cooling
mode indicator turns on.
- Press Up or Down to adjust temperature in a
range of 16~30°C (60,8~86°F).
- When the up or down is pressed once, tempera-
ture will go up or down by 1ºC every time.
- Press speed to select high, mid or low fan
speed.
HEAT MODE
- Press mode (d) to select heat mode, the Heat
mode indicator will light.
- Press (c) to adjust the temperature
- Press speed (b) to increase or decrease
speed.
FAN MODE:
- Press mode to select fan mode fan indicator
turns on.
- Press speed to select high, mid or low speeds.
- Temperature is not adjustable.
DEHUMIDIFYING MODE:
- Press "MODE" to select dehumidifying mode,
dehumidifying mode indicator turns on.
- Remove the plug of drainage cap, insert a tube
and put the other side of the tube into water
containers or drain channels.
- When entering dehumidification mode, if the
room temperatures is ≥17ºC, the compressor
will start to work.
- If the room temperature is ≤15ºC, compressor
stops; when the temperature rises back to
≥17ºC, the compressor restarts (the compres-
sor shall meet the 3minute delay protection
function).
- In dehumidification mode, the fan run in low
speed by default, and the wind speed are not
adjustable. ·Temperature cannot be set.
- NOTE: When the dehumidification function
is in use, the exhaust pipe assembly shall be
removed; otherwise it will lead to not obvious
dehumidification effect or display "FL" water full
alarm.
COMPRESSOR PROTECTION:
- Three minutes later after power on / restart,
compressor starts to run.
WATER TANK FULL PROTECTION:
- When the water level in the bottom water plate
is above the warning level, the unit will alert
automatically a.
- Please discharge water in the machine accor-