AFLAMO ROYAL Serie Benutzerhandbuch Seite 13

1 Set current day and time
1. Press once. When "MON" (Monday) begins flashing, use
2. Press . When the hour digits begin flashing, use
3. Press again. When the minute digits begin flashing, use
4. Press again. The current time is now set.
2 Set ON/OFF time and temperature on a weekly cycle
1. Press . When "MON" begins flashing, press
the desired hour and minute to turn on the heater.
"ON" timer.
note:
The timer can only be adjusted in 30-minute increments (i.e. 00:00 - 00:30; 00:30 - 01:00, etc.)
2. Press . When "OFF" beginsflashing, use
Press at any time to clear the digits and shut down "OFF" timer.
3. Press again. When "18" begins flashing, use
note:
If the temperature was previously set, those digits will be shown instead of "18".
4. Press again. When "TUES" appears on the screen and "ON" begins flashing, use
hour and minute to turn on the heater for Tuesday.
5. Press again. When "OFF" begins flashing, use
heater for Tuesday.
6. Press again. When "18" begins flashing, use
7. Repeat steps 1 to 6 to set the "ON/OFF" time and temperature for Wednesday, Thursday, Friday,
Saturday, and Sunday.
Press or
8.
middle of the appliance. The appliance will "beep" once to confirm that programming has been successful.
Open window warning
If the room temperature decreases by 10 degrees within 3 minutes, the appliance will assume there is an open window
nearby. In order to conserve energy, the heater will automatically switch from High Heat to Low Heat, or if the heater is
already at Low Heat, it will turn off completely.
When switching from High Heat to Low Heat, the appliance will beep 3 times and the digital display will flash "88" 3 times
before displaying the existing heating status.
When switching from Low Heat to Off, the appliance will beep 3 times and the digital display will flash "88" continuously.
To reset the heating function, see "operating remote control" section.
to complete programming, ensuring to aim the remote control at the receiver, located in the
www.aflamo.com
to select the current day.
to select the current hour.
to select the current minute.
3 times. When "ON" begins flashing, use
at any time to clear the digits and shut down
to select the desired hour and minute to turn off the heater.
to select the desired temperature for Monday.
to select the desired hour and minute to turn off the
to select the desired temperature for Tuesday.
to select
to select the desired
13