Werbung
EN
0 2
S A F E T Y N O T E S
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The hot and cold supplies must be of equal pressures.
I N S T A L L A T I O N I N S T R U C T I O N S
⁄ Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
⁄ The pipes and the fixture must be installed, flushed and
tested as per the applicable standards.
⁄ The plumbing codes applicable in the respective
countries must be observed.
T E C H N I C A L D A T A
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
⁄ Safety against backflow
⁄ The product is exclusively designed for drinking water!
S Y M B O L D E S C R I P T I O N
Do not use silicone containing acetic acid!
F A U L T
⁄ Insufficient water
⁄ Instantaneous heater didn't work
A S S E M B L Y (see page 04)
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 70°C
65°C
max. 70°C / 4 min
C A U S E
⁄ Aerator calcified, dirty
⁄ filter insert shower dirty
⁄ filter insert shower dirty
⁄ check valve hasn't moved back
M A I N T E N A N C E (see page 07)
The check valves must be checked regularly
according to EN 806-5 in accordance with
national or regional regulations (at least once a
year).
D I M E N S I O N S (see page 08)
F L O W D I A G R A M (see page 08)
C L E A N I N G (see page 10)
S P A R E P A R T S (see page 09)
O P E R A T I O N (see page 06)
R E M E D Y
⁄ Clean aerator, replace as necessary
⁄ Clean filter insert between shower and
hose
⁄ Clean filter insert between shower and
hose
⁄ Exchange check valves
Werbung
