Battery Controller BC X-PRO 60 Benutzerhandbuch Seite 14


The device is suitable for indoor use. Do not use the device outdoor and do not expose the device
to the atmospheric agents (rain, water, saltiness...).

The device is not intended for use by children or persons with reduced physical, mental or sensory
capabilities, or lack of enough experience and knowledge to understand the instructions on this
manual, except in the presence of a responsible person who can ensure the safe use of the device.
Keep out of reach of children and ensure that they cannot play with it.

Do not use the device to charge NiCd, NiMH or non-rechargeable batteries.

Please verify that the input and output cables are in good conditions before using the device. If the
input cable is damaged, do not use the device: ask the manufacturer or an authorized service agent
for repair or replacement. Do not connect the device to a damaged power outlet.

Do not try to recharge a frozen or damaged battery.

Do not cover the device during use.

Do not place the device close to heat sources. Do not use in environments with temperatures
above 50°C. In Power Supply mode, the device is designed to work at maximum power with
ambient temperatures up to 30°C.

The operating mode of the device and the restrictions applicable to its use are explained in the
following sections of this manual.

During the charging, a battery might produce explosive gases: avoid generating flames or sparks in
its proximity and place the battery in a well ventilated area, to avoid any risk of fire or explosion.
Protect the battery surface from any risk of short circuits.

Batteries contain a corrosive electrolyte. Wear protective goggles and gloves when operating in
proximity of the battery. In case the acid gets in touch with your skin or eyes, rinse them
immediately with plenty of water and ask for a doctor.
CONNECTION OF BC X-PRO 60

Before connecting/disconnecting the device to/from the battery, turn off the switch and disconnect
the device from the power outlet.

Connect first the battery terminal not connected to the chassis (usually the positive one, red clamp
to the positive + pole of the battery), then connect the other clamp to the chassis, far from the
battery, the fuel line and the tank. Then, connect the device to the power outlet and turn on the
switch.

After using the device, turn off the switch and disconnect the device from the power outlet first,
then disconnect the clamp connected to the chassis, then disconnect the clamp connected to the
battery, in this order.

WARNING: The charger must be connected to an earthed power outlet. The connection to the
power outlet must be carried out in compliance with national standards.
START UP OF BC X-PRO 60
1. Connect the device to the power outlet.
2. Turn on the device, placing the switch on "I". The digital display turns on, showing «BC X-PRO - fw
x.x»
3. The charger is set to the last configuration used. To change the operating mode (Battery Charging,
Power Supply...), the parameters (battery type, current, voltage...) or the language, follow the
instructions in the next paragraphs.