Teaching-In; Operation - HomeMatic HM-LC-Sw4-PCB Bedienungsanleitung

7.2 Teaching-in

Please read this entire section before starting to
carry out the teach-in procedure.
To execute the teach-in procedure, both of the
devices to be connected must be in teach-in mode
and the channel to be taught-in must be selected.
The switching actuator PCB does not feature a
special teach-in button.
To teach-in to a particular actuator channel,
hold the corresponding channel button down for
approximately four seconds. If the channel LED
flashes continuously, this signals that teach-in mode
is active.
If no teach-in is carried out, teach-in mode will
be exited automatically after 20 seconds. If other
devices are also in teach-in mode, they will be
taught-in.
8

Operation

After teach-in has been performed, simple operator
functions are available via the taught-in control
elements. Depending on the taught-in control
element, the switching actuator can be controlled by
means of an ON/OFF pair of buttons or by toggling.
25