Technical Specifications; Electrical Diagram - Blaupunkt PW7200i Bedienungsanleitung

WATER INLET FILTER
The water inlet filter must be inspected regularly, so as to avoid blockage and restriction in the water supply to the pump
LONG TERM STORAGE
The pressure washer should always be stored in a dry, frost free environment. To ensure a long operational life it is advised
that use the machine occasionally to prevent scaling in the pump.
NOZZLE TIP CLEANING PIN
• Using included tip cleaner, or an unfolded paper clip, insert
wire into the nozzle hole and move back and forth until
debris is dislodged.
• Remove additional debris by back-flushing water
through the nozzle. To do this, place end of a garden hose
(with water running ) to the end of nozzle for 30-60 seconds.
ASSEMBLY INSTRUCTIONS
• Attach the cable storage hook to the pressure washer.
• Attach the top and bottom sections of the lance holder.
• Connect the lance handle, extension and nozzle tip together.
• Connect the high pressure hose to the handle.

TECHNICAL SPECIFICATIONS

MODEL
Working flow rate
Max. flow rate
Working pressure
Allowable pressure
Max. pressure water supply
Motor Capacity
Power Supply Voltage
Max. Water Temperature
Weight
Dimensions(CM)

ELECTRICAL DIAGRAM

11MPa(110 bar)
16.5MPa(165 bar)
0.4MPa(4 bar)
230-240V/50Hz
36.5 x 35 x 78.5
SWITCH1
RED
SWITCH2
BLACK
YELLOW / GREEN
NOSE
PW7200i
360 L/h
432 L/h
2100W
50ºC
20 kg
RED
WORKING
WINDING
START
WINDING
GREEN
MOT. 1 ~
EN
TIP CLEANER