Parts Diagram - Blaupunkt PW7200i Bedienungsanleitung

WARNING:
When the machine is running, please maintain a constant water supply. Without water circulation will damage the
sealing rings of the machine.
WARNING:
It is necessary to turn on the spray lance within one or two minutes after the machine has been started. Otherwise, the
temperature of the circulating water within the machine will soon rise to a critical point, which will cause damage to
the sealing rings inside the machine.
WARNING: Don't start and run the machine in a place excessively cold so as to prevent the machine from the freezing
current.
WARNING:
This machine has been designed for only using cleaning water, do not use corrosive chemicals.
WARNING:
Use cleaning agent supplied or recommend by the manufacturer.
WARNING:
High-pressure jets can be dangerous if subject to misuse. The jet must not be directed
at persons, animals, live electrical equipment or the machine itself. Pressure washers should
not be pointed at tire walls, as it may be possible to damage them.
WARNING:
Do not direct the jet against yourself or others in order to clean clothes or footwear.
WARNING:
Disconnect from the electrical power supply before carrying out user maintenance.
If the mains cable is damaged it must be replaced by the manufacturer, or its service agent or similarly qualified person
to avoid a hazard.
WARNING:
Do not use the machine if a supply cord or important parts are damaged, e.g. safety devices, high pressure hoses,
trigger gun.
WARNING:
Be aware of the recoil caused by the water jet when the machine is switched on.
WARNING:
When the machine is moving and installing, the machine must be in flat. When moving the machine, pulling the
handle to move it.
WARNING:
Connect to the water supply. The machines are not suitable for connection to portable water mains. Connect the
machine to the water supply. (It can be a water container).
Make sure the inlet water pressure keeps between 0.01MPa and 0.4MPa.The inlet pipe should at least 5 M long. Do
not use the pipe if the pipe is damaged. If you want connect this machine to portable water mains, you must install
a backflow preventer in the water pipe to prevent dirty water flow back to the drinking water system. The backflow
preventer shall comply with EN 60335-2-79 ANNEX AA.

PARTS DIAGRAM

1. High pressure washer
2. On/off switch
3. Lance Holder
4. Cable Storage Hook
5. Water inlet
6. Lance
7. Hose Reel
8. Hose Reel Handle
9. Telescopic Handle
10. Detergent Tank (behind)
9
8
2
4
10
7
3
1
5
EN
6