Operation - Camp 4 30 MBAR Betriebsanleitung

Lighting Oven Instruction
Do not lean over the oven while lighting
1. Remove all appliances from the oven to create a free flow of air.
2. Open oven door. Do not attempt to light the oven with the door closed.
3. Remove the bottom oven tray to reveal the burner.
4. Push the gas valve handle in and turn slowly to the high position. The oven burner will ignite. (If lighting
with a match, light match and place it over the burner. Slowly turn on the valve, Do not stand with head
or arms over the burner.)
5. Keep handle depressed for 10 seconds.
6. If the burner does not stay lit repeat the process.
7. Re-install the bottom oven tray over the burner.
8. Adjust the controls to the desired position.
9. If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes, and repeat the
lighting procedure. If built-in ignitor will not light follow instructions for lighting with a match.
Burner Flame Check
Light burner
rotate knob(s) from HIGH to LOW. You should see a small flame in LOW position than seen on HIGH.
Always check flame prior to each use. A good flame should be blue with minimal yellow tip. Some yellow
tips on flames are acceptable as long as no carbon or soot deposits appear.

OPERATION

• After you have ignited the gas stove or oven, you can adjust
the control knob, which as the drawing shows, for your ideal flame and
temperature you want.
• Do not put any items on the glass door see the picture shown.
• Do not exceed 4.5kg on the oven shelves.
• Pay attention to the high temperature when temeprature
raise of outer body over 50°C.
• Turn off the gas supply at the gas container after use, any
modification of the appliance may be dangerous.
• Do not move the appliance during operation.
• Keep children and pets away from burner at all times.
• This appliance will be hot during and after use. Use insulated oven
mitts or gloves for protection from hot surfaces or splatter from
cooking liquids.
Yellow
Yellow
Blue
Blue
Holes in burner
15