Camp 4 30 MBAR Betriebsanleitung Seite 13

Parts list
When you open the box of camp stove, you may find two important parts:
• The camp stove body 1pc
• The wire pan-grate 1pc
• The oven rack 2pcs
• The oven tray 1pc
Notice
1. The wire pan-grate is on the top burner.
2. The oven rack and tray is in the oven.
3. The connection hose and regulator is in the oven.
Setup Instructions
• Setup the oven on a level, non-combustible surface.
• Open the lid and attach the windsreens to the side of the oven as shown.
• Make sure the pot grate is installed properly with the wire ends fitting into the holes on the top
of the oven to present the rack from moving (see picture)
Connect the gas to camp stove
Notice
1. Use the regulator recommended by manufacturer or seller.
2. Before you assemble the regulator, please check the gas type and pressure shown on the gas cylinder,
and make sure the information on the regulator and cylinder match.
3. The hose connecting the appliance and gas cylinder is required, and the max. length
should not exceed 1.5 m.
4. The connecting hose could not be twisted & knoted .
5. Change the connecting hose when the national conditions require.
Connect
1. Be sure that the burner & oven valves are in the "OFF"position before you connect the stove
to a gas or propane supply line.
2. Connect the inlet of the stove with the outlet of the gas regulator.
This connecton must be made with a specialised hose for LP gas.
3. Be sure that the hose is placed correctly and is not being stretched, tied, or bent.
4. Also be sure that the hose is not too close to heat sources, especially with the back of the camp stove.
5. It is recommended that a manual gas valve is placed between gas pressure regulator and the inlet of
the stove to open or shut off the gas supply. This valve must be in an easily accessible location.
13