Scandomestic SFS 226 W Bedienungsanleitung Seite 17

2. Pry the hinge cover up and off, remove the three screws that secure the upper
hinge to the door, then remove the hinge.
3. Remove the freezer compartment door from the cabinet.
4. Remove the screws that secure the lower hinge to the right side of the cabinet,
then remove the hinge.
5. Remove the washer and nut that secure the pin shaft to the right hole on the
lower hinge, then remove the shaft
6. Insert the pin shaft into the left hole on the lower hinge, then secure the shaft
with the washer and nut.
7. Install the lower hinge on the left side of the cabinet.
10. Remove the screw that secures the door stop from the bottom right of the
freezer compartment door, then remove the door stop and install to the bottom
left side.
8. Install the freezer compartment door.
9. Move the door bushing from the top right side of the freezer door to the top
left side of the door. And move the left hole cover to the right side.
10. Remove the screw that secures the hinge screw hole cover from the top left
side of the cabinet, remove the cover and secures the cover on the top right side
of the cabinet.
11. Secure the upper hinge to the top left side of the cabinet with the three screws
you removed previously. Before you tighten the upper hinge screws, make sure
that the top of the door is level with the cabinet and that the rubber gasket makes
a good seal.
20. Install the hinge cover over the hinge on the top left side of the cabinet.
12. Remove the left hole plugs, screw off the bolts, and remove the right hole
plugs.
13. Install the right hole plugs on the left side of the door, and install the handle
on the right side of the door.