Gastroback BARTENDER PRO Bedienungsanleitung Seite 42

CAUTION
refrigeration circle and damage the compressor. Ensure that the appliance will not
tilt or fall and cannot be pulled by the power cord, when moving the appliance
to the edge of the workspace for emptying the water tank. After draining the
water, DO NOT leave the appliance stand on the edge of the workspace.
Clean the appliance regularly—at least every week and before storage. Daily empty
the water tank and fill in fresh cold drinking water for avoiding the build-up of germs
and algae as well as a stale taste of the ice.
For cleaning, only use a lukewarm mixture of vinegar, clean dinking water and a
droplet of a diswasher concentrate. Do not use scouring pads or abrasive or corro-
sive cleaning agents (e.g. bleach, solving agents) for cleaning the appliance or any
parts of it, to avoid damage to the surfaces and seals.
Do not pour any hot liquids into the water tank, for avoiding damage to the
appliance.
1. Switch off the appliance (press the power button, operation indicator
) and wait, until the ice producing system reaches the standby position
(approx. 1 minute). Then unplug.
2. Open the lid, remove the ice container, and place it on a suitable pad (shallow
bowl or tablet).
3. While waiting for the appliance to reach room temperature: Remove remai-
ning ice. Wash the ice container and ice shovel with warm dishwater, rinse
thoroughly with clear water and wipe dry.
4. After the appliance reached room temperature: When there is still water in the
water bowl within the ice producing system, gently push the water bowl back,
until the water runs out completely. If required, place an absorbant cloth on the
floor below the appliance. Hold a sufficiently large vessel at hand (capacity: up
to 3 litres).
IMPORTANT - Please keep in mind that the appliance is heavy. For moving the
appliance, always grasp it at both sides at the bottom of the housing. Do not pull
or push the appliance by the cover, lid, or power cord. Avoid tilting the appliance.
Making the drain plug accessible: Carefully move the appliance to the edge of the
workspace, until the front of the appliance protrudes the working surface approx.
5.5 cm (approx. 2 inch). Ensure that the appliance stands stably and will not tilt
and the drain plug at the right edge in the bottom of the appliance is accessible.
5. While holding the vessel below the drain plug, pull the drain plug out. Leave the
water run out. Thereafter, replace the drain plug and gently push it in place.
EN
42
– Do not tilt the appliance for avoiding that bubbles get into the
flashes