Gastroback BARTENDER PRO Bedienungsanleitung Seite 40

Problem
The ice container indicator
is illuminated continu-
ously. The appliance stop-
ped working.
The ice container indicator
is flashing.
The ice container is full..
Although the ice contai-
ner indicator
dark.
You cannot select the
cleaning function.
The appliance is not wor-
king.
The ice pieces build clods.
EN
40
Reason
The ice container is full.
The light barrier of the
water tank is obstructed.
The light barrier is defec-
tive.
The ice producing system
is blocked. May be a piece
of ice is caught in the ice
rake or water bowl.
Sunlight is influencing the
light barrier.
stays
The cleaning function is
only available, while the
appliance is switched off.
The ice container is not
inserted correctly.
A severe problem occur-
red.
The cooling cycle is taking
too much time.
The temperature in the
water tank is too low.
The Solution
Remove a sufficient amount of ice (see: 'Operation').
A piece of ice may be caught in the light beam. Ensure
that the ice bullets fall freely into the ice container.
Switch off and unplug the appliance. At both sides of the
water tank clean the light barrier diodes.
Unplug the appliance. Return the appliance to an authori-
sed service centre for examination and repair.
Switch off and unplug the appliance. Remove the obsta-
cle. Then try again.
Do not use violence! If you find it difficulty to remo-
ve an ice bullet from the ice producing system, remove
the ice container and leave the appliance stand with the
lid open, until the ice has been molten away.
Protect the appliance against direct sunlight.
CAUTION: If you wish to move the appliance, switch
off and unplug the appliance first. Otherwise, the com-
pressor may get damaged.
Switch off the appliance (operation indicator flashes).
Then try again.
Remove the ice and insert the ice container correctly via
the handles. For operation, the somewhat higher sidewall
must face to the rear of the appliance. Ensure that the lid
can be closed completely.
Immediately unplug the appliance. Get in contact with an
authorised service centre for examination and repair.
Switch off the appliance. With the lid open, wait until the
ice is molten. Then close the lid and try again.
The water temperature must be between 8°C (47°F)
and 25°C (77°F). If required, remove some water. Then
fill some water of 20-25°C into the water tank.