Advice Should The Following Occur - Silca Air4 Home Gebrauchsanleitung

Air4 Home-Air4 Home PRO
1. Open the device to access the battery compartment and remove the batteries.
2. Use a drill to carefully drill the back of the device; make sure to use a bit with a suitable diameter for the
chosen cable gland . (Fig./Abb.8)
3. Carefully drill the cable gland with the power cable.
4. Carefully remove any plastic shavings from the device . (Fig./Abb.9)
5. Remove the circuit board's protective cover by unscrewing the two screws. (Fig./Abb.7)
6. Change the position of the jumper as shown in the figure. (Fig./Abb.12)
7. Connect the power cable to the board's connector as per the indicated polarity.(Fig./Abb.13)
8. Reposition and secure the circuit board's protective cover and the device's bottom
WARNING: do NOT reinsert the batteries.

14. ADVICE SHOULD THE FOLLOWING OCCUR

The Air4 Home (Air4 Home Pro) won't detect the remote control.
Nothing happens when the remote control button is pressed and after 30 seconds, the app displays an error
screen.
Possible causes:
- The remote control uses an unsupported frequency (e.g. it is a quartz remote control).
- The remote control is very powerful and must be kept further away from the Air4 Home (Air4 Home Pro).
- The remote control's batteries are dying and it must be kept closer to the Air4 Home (Air4 Home Pro) or the
batteries must be replaced.
The Air4 Home (Air4 Home Pro) won't copy the remote control.
The app immediately displays an error screen when the remote control button is pressed.
Possible causes
- The remote control is very powerful and must be kept further away from the Air4 Home (Air4 Home Pro).
The gate or garage will not open.
The copying procedure was completed without errors, but when you get to the final test screen, the gate or
garage won't open.
Possible causes:
- The remote control is not a compatible model.
- The remote control has not been copied within 10 metres of the gate/garage receiver
- If the remote control type is an "automatically-recording rolling code," the receiver's automatic remote
control recording function is disabled (or not supported). Consult the receiver manual and follow the in-
structions regarding copying a new remote control.
- If the remote control type is a "rolling code with a secret code," and is a "FAAC" or "GENIUS" model, the
remote is a "SLAVE" model, instead of a "MASTER" model. "SLAVE" remote controls cannot be copied and
it's therefore necessary to obtain the "MASTER".
- To identify the remote control type, press the remote control button that opens the gate or garage, and
check what kind of flash is emitted from the remote's LED: 1. If it flashes briefly before becoming steadily lit,
it is a MASTER. 2. If it immediately becomes steadily lit, it is a SLAVE remote control and cannot be copied.
- If the radio control is of type V2, there is a guided procedure inside the APP to perform the copy with
identical serial.
- At the beginning of the copy procedure (1st SCREEN) press the three dots (
follow the instructions.
14
PROCEDURE
Copyright Silca S.p.A 2020
English
shell.
) in the upper right corner and