Procedure; Inserting Batteries - Silca Air4 Home Gebrauchsanleitung

Air4 Home-Air4 Home PRO
INITIAL INSTALLATION PROCEDURE
1. Open the device, insert the batteries the correct way round and close the device by tightening the screws
on the back. (Fig. /Abb.1-2)
2. To start using Air4 Home (Air4 Home Pro), download the "Air4 Home" app for free from the Android Play
Store™ or Apple Store™, and follow the instructions to copy your remote controls.
COPYING PROCEDURE
1. Make sure the remote control batteries are fully charged.
2. Use Easy Scan Plus to ensure the remote control is compatible with Air4 Home (Air4 Home Pro) or consult
the list of compatible remote controls on the website www.silca.biz or by consulting the list available
through the app.
3. Start the downloaded App by selecting the Air4 Home (Air4 Home Pro) device and use the remote control
COPYING PROCEDURE.
4. The App will ask you to press the remote control key.
5. It is important to keep the right distance between the remote control and Air4 Home (Air4 Home Pro)
device (advisable between 2 cm and 5 cm).
6. It is important that the original remote control is in the right position (Fig./Abb.10).
7. Start the downloaded App by selecting the Air4 Home (Air4 Home Pro) device and use the remote control
COPYING PROCEDURE.
ASSEMBLY PROCEDURE
1. MOUNTING TO THE WALL: Fix the bracket to the wall via the screws and wall plugs, and secure the device
in the bracket using the screw and nut. (Fig./Abb.4-5)
2. MOUNTING TO A POLE: Secure the device in the bracket using the screw and nut, insert the clamps into
the bracket, and attach it to the pole. (Fig./Abb. 4-5-6)
For both mounting methods, the height at which to place the device must be less than 2 meters above the
ground.
Please dispose of used batteries in accordance with the local regulations, and separately from household
waste. The device requires 2 x 1.5 V C-type alkaline batteries (R14); these are pre-inserted in the device at the
time of purchase. Make sure that only new batteries are used, every time that the batteries are replaced. We
recommend using alkaline batteries for a longer service life. The Air4 Home (Air4 Home Pro) device has a rated
voltage of 3.3 V and a power output of 0.3 W.
To replace the batteries, proceed as follows (Fig./Abb.1):
1. Turn the device upside down, unscrew the 4 screws with a Phillips screwdriver and remove the battery
cover. (Fig./Abb.2)
2. Insert the new batteries the right way around, so that the positive (+) and negative (-) ends are in the right
place, as indicated on the labels affixed to the battery compartment. (Fig./Abb.1)
Only use and replace the old batteries with batteries that are a suitable size and type (alkaline, zinc-carbon
or zinc chloride).
IMPORTANT NOTE: There is a risk of explosion IF WRONG OR DAMAGED BATTERIES
ARE USED (e.g. if there is oxidation, liquid leaking or deformation).
12

8. PROCEDURE

9. INSERTING BATTERIES

Copyright Silca S.p.A 2020
English