Maintenance - Bell & Ross BR03-92 DIVER Technische Anweisung

: The 4 slotted screws (D) mount the bezel to the case and ensure the water
Note
resistance of the watch. To benefit from the Bell & Ross warranty, these screws must
never be unscrewed.
STRAP MOUNTING
Attachments (E) with screws on the outer face of the lugs
Attachments (E) with no visible screws

MAINTENANCE

After being immersed in seawater, it is recommended to carefully rinse off the watch
and strap with fresh water. It is also recommended to have the water resistance of
your watch checked every two years. To ensure a service that meets the brand's exact-
ing standards, any servicing of your watch must be carried out by the Bell & Ross
service centre or a watchmaker approved by Bell & Ross. Whenever repairs are made
during the warranty period, you must present the Bell & Ross warranty card, duly
dated and signed by the retailer at the time the watch was purchased.
The 4 socket head screws (hexagon socket/1.3 mm
diameter) mount the strap to the case attachments.
These screws must be handled carefully, using the
2 tools supplied with the watch in its box.
A spring bar is used to fit the strap to the case attach-
ments. This bar must be removed carefully using the
appropriate tool provided with the watch in the box.
5
A. Minute hand
B. Hour hand
C. Second hand
D. Case attachment screws
(NEVER UNSCREW)
E. Strap attachment
F.
Unidirectionnal rotating
bezel
G. Date
H. Crown
0. Unscrew the crown
(rotate anticlockwise)
1. Wind the movement
manually (rotate
clockwise)
2. Set the date (rotate
anticlockwise)
3. Set the time (rotate
in either direction)