DeLonghi DDSX 220WFA Handbuch Seite 11

Air filtration
If the HEPA-type (E12)* (A7) is installed, in addition to operating
in the preset mode, the appliance will also filter the air in the
room. In this case, the symbol (C2) will appear on the display.
The filter is designed to last up to 9 months, based on 8-hour
daily usage at medium working load.
To maintain the efficiency of filtration, see paragraph "10.3
Replacing the HEPA-type (E12)* filter".
4.1 Dehumidifying mode
1. Touch the button (B3). The
blink on the display (fig. 7).
2. The display shows the previously set relative humidity
value. When the
changed by repeatedly touching the
There are 9 different relative humidity settings ranging
from 30% (dry environment) to 70% (humid environment).
Depending on the environmental conditions, it may not be
possible for the appliance to reach the minimum settable
value. In these cases, it is recommended the heat the
environment that needs to be dehumidified.
3. When the symbol stops blinking, the display shows the
percentage of relative humidity in the room. The appliance
may take a few seconds to display the value of the relative
humidity in the room.
4. When the room reaches the preset relative humidity level,
the appliance stops dehumidifying and operates at a very
slow ventilation speed.
4.2 Dry mode
1. Touch the button (B6). The display shows the
symbol (C7) (fig. 8).
Please note:
The appliance automatically operates at the maximum
dehumidifying capacity. Recommended for particularly humid
environments or to dry laundry more quickly.
4.3 Ventilation mode
1. Touch the button (B2). The display shows the
symbol (C3) and the selected speed (fig. 9).
2. When the symbol blinks, the ventilation speed can be
adjusted by repeatedly pressing the
display shows the number corresponding to the selected
speed (1 ⇒ LOW; 2 ⇒ MED; 3 ⇒ HIGH).
4.4 Swing function
1. Press the button (B5)
moves up and down, evenly distributing the air flow in the
room (fig. 10).
2. To stop the louver in the desired position, touch the same
button again.
symbol (C9) will
symbol blinks, the setting can be
button. the
. The air outlet louver (A1)
4.5 Timer function
The timer can be used to delay appliance start-up and shut-
down. This will avoid energy wastage, ensuring the appliance
operates only when needed.
The timer function can be programmed from either the control
panel or the app.
• If programmed from the control panel: the display shows
the symbol (C12) (fig. 11).
• If programmed from the app: the display shows the
symbol (C11) (fig. 12). To programme the timer from the
app, follow the instructions provided in the app.
How to programme delayed start-up
1. With the appliance in stand-by (
button (B7): the display will show the
button.
number relative to the selected hours (fig.11);
2. Set the desired number of hours by repeatedly touching
the
3. After a few seconds, the appliance will return to stand-by
mode and the
4. After the programmed time, the appliance will turn on in
the previously set operating mode.
How to programme delayed shut-down
1. While the appliance is running, touch the
(B7): the display shows the
number of selected hours (fig. 11);
2. Set the desired number of hours by repeatedly touching the
3. After a few seconds, the display returns to the current
operating mode and the
4. After the programmed time, the appliance will
automatically turn off.
Please note:
• Once the timer has been programmed, to see the remaining
time until start-up or shut-down, touch the
button once.
• To deactivate the timer function, press the
twice. The
4.6 Wi-Fi function
The appliance has a built-in Wi-Fi function. To activate or
deactivate this function, hold the
until the appliance emits two beeps. When the Wi-Fi function is
active, the display will show the
following operating modes:
FIXED
-
this means the Wi-Fi functions are active and the
"Home WLAN" has been found
- SLOW FLASHING
this means the appliance is searching for the
"Home WLAN"
11
button.1, 2, 4, 6, 8, 12 hours can be selected.
symbol will remain lit on the display.
symbol and the relative
button. 1, 2, 4, 6, 8, 12 hours can be selected.
symbol remains lit.
symbol on the display will turn off.
Wi-Fi symbol (C5) with the
), touch the
symbol and the
button
button
button (B4) pressed