Operating The Compressor; Using The Adapter - Eufab 21076 Bedienungsanleitung

6.2 OPERATING THE COMPRESSOR

In order to be able to work with the compressor, fi rst take the
air hose (Position 6 in the overview) and the connection cable
(Position 5 in the overview) from the storage compartment
(Position 7 in the overview).
Make sure that the compressor is switched off
before connecting it (both switches, Positions 3
and 4 in the overview, may not be pressed).
6.2.1 FILLING A TYRE USING THE CAR VALVE
SCHRADER VALVE
Open the lock on the valve connection
Place the valve connection on the valve
Lock the valve connection
You can now fi ll the tyre using the compressor
Connect the compressor to the power supply. Either to the
12 V connection in your vehicle or to a 230 V household
connection.
8
Figure 5
Figure 6
Figure 7
Figure 8
CAUTION
Do not connect the compressor to both the
230 V household connection and the 12 V
socket of your vehicle at the same time.
Switch the compressor on to fi ll. When connecting to a 12 V
vehicle socket, press the right switch (Position 3 in the
oveview) on the front of the device. When connecting the
compressor to the 230 V household network, press the left
switch (Position 4 in the overview).
The manometer (Position 2 in the overview) is designed to
monitor the air pressure. When the desired air pressure is
reached, switch off the compressor by pressing the appropria-
te On/Off switch. Remove the valve connection in reverse order
(Figures 8-5).
When lling, always pay attention to the
correct air pressure (consult the operating
instructions of your vehicle for informati-
on). The compressor is able to supply a pres-
sure of up to 8.3 bar. If the pressure is too
high, there is a risk of explosion and injury.
Never allow the compressor to operate for
longer than 5 minutes without a pause,
otherwise there is a risk of overheating.
Switch the compressor o after 5 minutes of
use and allow it to cool down fully (at least
20 minutes) before starting it up again.
Never leave the compressor to operate
unattended.
The compressor may discharge the battery
of your vehicle if the motor is switched o .
If you use the compressor with the vehicle
motor running, ensure good ventilation in
the garage or hall. There is a risk of poiso-
ning!
After fi lling a tyre, check the tyre pressure again using a
separate air pressure tester (e.g. at a fi lling station, vehicle
workshop).

6.2.2 USING THE ADAPTER

Open the lock of the valve connection (Figure 5). Insert the
appropriate adapter for the required purpose into the valve
connection. Lock the valve connection (Figure 7). Insert the
adapter into the fi lling connection of your leisure equipment
(ball, infl atable toys etc.). Depending on version, it is possible
that the adapter will need to be held fi rmly during the fi lling
process. Now you can switch on the compressor and start
the fi lling process. When the desired air pressure is reached,
switch off the compressor by pressing the appropriate On/
Off switch. Remove the adapter from the valve connection by
proceeding in reverse order, as described above.