Additional Anti-Limescale Filter; What If There Are Problems - Sanitas SLB 40 Gebrauchsanweisung

8. Additional anti-limescale filter

TIP!
If the water is hard, we recommend using the optional anti-limescale filter (see section "12. Replacement
items").
Note
• If the anti-limescale filter does not prevent limescale build-up, or if white deposits form on or in the
device, the anti-limescale filter should be replaced.
• The service life of the anti-limescale filter is around 2 to 3 months at most.
• If the device is not used for a relatively long time, the anti-limescale filter must be removed from
the water tank and dried out.
Fitting the anti-limescale filter
1. Ensure that the device is switched off.
2. Remove the water tank from the base unit in an upward direction.
3. Turn the water tank over.
4. Open the screw plug on the water tank.
5. Screw the anti-limescale filter on the screw plug thread of the water tank.
6. Close the screw plug on the water tank. The anti-limescale filter is now
fitted.

9. What if there are problems?

Problem
No mist is produced
The mist has a strange
smell
Strange noise
Mist escapes from
underneath the water
tank
Cause
The mains cable is not plugged in. Plug the mains cable into a suitable
The control dial is in the off
position.
The water level is too low; the
water tank is empty.
The device is new.
Stale or dirty water.
The water tank is not positioned
correctly on the base unit.
There is too little water in the water
tank.
The device is not level and unstable. Place the device on a firm, level surface.
The water tank is not positioned
correctly on the base unit.
Solution
socket.
Turn the control dial clockwise towards the
maximum position.
Fill the water tank.
Lift up the water tank, turn the screw plug
and remove it. Air the open, empty water
tank in a cool, dry place for 12 hours.
Empty the base unit and the water tank
and clean them thoroughly. Fill the water
tank with fresh water.
Lift up the water tank and position it cor-
rectly on the base unit. The tank should sit
tightly on the base unit.
Fill the water tank.
Lift up the water tank. Check whether the
join between the base unit and water tank
is clean. Clean if required. Position the
water tank correctly on the base unit. The
tank should sit tightly on the base unit.
19