Initial Use; Installation Location; Filling The Water Tank - Sanitas SLB 40 Gebrauchsanweisung

5. Initial use

Unpacking the device
WARNING
Keep packaging material away from children. There is the risk of suffocation.
1. Open the cardboard packaging.
2. Remove the protective insert. Keep the plastic film closed.
3. Lift the device up and out of the packaging.
4. Remove the plastic covering.
5. Check the device, the mains plug and the cable for damage.

Installation location

WARNING
Read the safety notes before putting the device into operation.
Note
• The immediate vicinity of the air humidifier can become damp.
• Calcareous water can leave white deposits.
• Do not place the device on the floor, but in a raised position (e.g. on a table or chest of drawers).
• Position the device so that the mist outlet is not directed towards objects.
• Do not use the air humidifier in rooms with significant temperature variations since this could lead to
condensation inside the device.
• Empty any remaining water when the device is not in use.
• Place the air humidifier on a firm, level and water-resistant surface.
If the device should accidentally tip over, water may escape, even if the device is switched off and unplugged.
Water
Note
• Do not add any essential oils or fragrances to the water. If additives are used, the plastic material may
become discoloured and damaged. The ultrasound membrane gets stuck and is damaged.
• Use fresh drinking water in the device. If the drinking water is very hard, you can use demineralised or
distilled water.
• Use warm water (30°C-45°C) and always fill the tank to the maximum level, otherwise the device could
leak due to physical factors.
• Tip! If the water is hard, we recommend using the optional anti-limescale filter.

Filling the water tank

1. Remove the water tank from the base unit in an
upward direction.
2. Turn the water tank over. The water tank is kept
closed by means of a spring valve.
3. Open the screw plug on the water tank.
4. Fill the water tank with warm water (30°C-45°C).
The water tank holds a maximum of 4.0 litres. The
water level is visible from the outside.
5. Close the screw plug on the water tank tightly.
6. Turn the water tank over.
7. Place the water tank on the base unit.
Ensure that the water tank is sitting firmly on the
base unit.
16