AFLAMO AV-WM33ALB/WH Bedienungsanleitung Seite 12

2 Set ON/OFF time and temperature on a weekly cycle
1. Press . When "MON" begins flashing, press
the desired hour and minute to turn on the heater.
"ON" timer.
note:
The timer can only be adjusted in 30-minute increments (i.e. 00:00 - 00:30; 00:30 - 01:00, etc.)
2. Press . When "OFF" beginsflashing, use
Press at any time to clear the digits and shut down "OFF" timer.
3. Press again. When "18" begins flashing, use
note:
If the temperature was previously set, those digits will be shown instead of "18".
4. Press again. When "TUES" appears on the screen and "ON" begins flashing, use
hour and minute to turn on the heater for Tuesday.
5. Press again. When "OFF" begins flashing, use
heater for Tuesday.
6. Press again. When "18" begins flashing, use
7. Repeat steps 1 to 6 to set the "ON/OFF" time and temperature for Wednesday, Thursday, Friday,
Saturday, and Sunday.
Press or
8.
middle of the appliance. The appliance will "beep" once to confirm that programming has been successful.
Open window warning
If the room temperature decreases by 10 degrees within 3 minutes, the appliance will assume there is an open window
nearby. In order to conserve energy, the heater will automatically switch from High Heat to Low Heat, or if the heater is
already at Low Heat, it will turn off completely.
When switching from High Heat to Low Heat, the appliance will beep 3 times and the digital display will flash "88" 3 times
before displaying the existing heating status.
When switching from Low Heat to Off, the appliance will beep 3 times and the digital display will flash "88" continuously.
To reset the heating function, see "operating remote control" section.
When the heater is first turned on, a slight odor may be present. This is normal and
NOTICE
should not occur again unless the heater is not used for a long period of time.
To improve operation, aim the remote control at the front of the fireplace. DO NOT
NOTICE
press the buttons too quickly. Give the unit time to respond to each command.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature, the heater will automatically turn OFF. To reset:
to complete programming, ensuring to aim the remote control at the receiver, located in the
www.aflamo.pl/en/
3 times. When "ON" begins flashing, use
at any time to clear the digits and shut down
to select the desired hour and minute to turn off the heater.
to select the desired temperature for Monday.
to select the desired hour and minute to turn off the
to select the desired temperature for Tuesday.
to select
to select the desired
12