Electronic Speed Controller (Esc) - Horizon Hobby ARRMA 4x4 3S BLX Bedienungsanleitung

ND
Motor wires x 3
Power Switch & Set button
Input Voltage
Throttle
Setup
1. TX in neutral - press set
OM

Electronic Speed Controller (ESC)

Only use fully charged LiPo batteries (4.2V per cell) to prevent
battery/ESC damage.
Battery Plug
2S-3S LiPo (7.4-11.1v)
6-8 Cell NiMh (7.2v-9.6v)
Req.
Connect batteries, turn on TX and press/hold the set button 'A'. Turn the switch on
'B' and release the set button when the RED light flashes on the ESC.
button (1 Green flash)
4. Switch off ESC to complete setup
www.modellmarkt24.ch
ESC Specifications
35C 5000mAh Minimum
2. TX full throttle - press set
button (2 Green flashes)
15
WARNING: Heat sink
may be hot after use.
Receiver Plug (CH2)
BEC Output 6.0v/6A Max
3. TX full brake - press set
button (3 Green flashes)
A
WWW.ARRMA-RC.COM
B