Miele HS17 Gebrauchsanweisung Seite 56

en
Problem
The robot vacuum
cleaner does not return
to the base station after
vacuuming.
56
Cause and remedy
The Auto standard vacuuming mode was started
somewhere in the room.
 The robot vacuum cleaner will return to its starting
point.
The Spot vacuuming mode has been selected.
 The robot vacuum cleaner will return to its starting
point.
There is insufficient light for the robot vacuum cleaner
to navigate.
 Provide sufficient lighting.
The base station is not connected correctly.
 Connect the base station exactly as described in
these operating instructions.
The sensors on the robot vacuum cleaner are dirty.
 Clean the sensors carefully using a dry cotton
wool bud.
The signal between the infrared transmitter on the
base station and the vacuum cleaner is broken.
 Clean both parts carefully with a soft, dry cloth
and make sure that no items disrupt the signal.
Obstacles on the floor which is to be vacuumed can
impede navigation.
 Watch the robot vacuum cleaner during vacuu‐
ming.
 Remove any obstructions.
 Define the area they are in with the magnetic strip.
 Reduce the maximum crossing over height, see
"Use - Reducing the maximum crossing over
height".