Description; Purpose; Overview; Safety - GreenWorks 1500107a Bedienungshandbuch

1

DESCRIPTION

1.1

PURPOSE

The machine is used to cut all types of wood.
1.2

OVERVIEW

Figure 1.
Lock-off button
1
Switch trigger
2
Spindle lock button
3
Laser guide
4
Edge guide
5
Bevel adjustment
6
knob
Width adjustment
7
knob
Blade guide notch
8
@ 45°
Blade guide notch
9
@ 0°
2

SAFETY

WARNING
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

3.1

UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine
before use.
WARNING
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
English
10 Blade
11 Lower guard
12 Outer flange
13 Blade bolt
14 Base
15 Lower guard lever
16 Depth adjustment
lever
17 Hex key
3.2

INSTALL THE BATTERY PACK

Figure 2.
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.3

REMOVE THE BATTERY PACK

Figure 3.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
3.4

INSTALL THE BLADE

Figure 4.
Before you install the blade, remove the battery pack
and keep the inner flange on the spindle.
1. Use the lower guard lever to lift the lower guard and
hold the lever.
2. Install the new blade.
3. Put the outer flange and the blade bolt on the
spindle.
4. Use the hex key to tighten the bolt
counterclockwise.
5. Push the spindle lock button to tighten the blade.
The arrow on the blade points the same direction as
the arrow on the top guard.
3.5

REMOVE THE BLADE

Figure 5.
Before you remove the blade, remove the battery
pack.
1. Push the spindle lock button to lock the spindle.
2. Use the hex key to loosen the blade bolt clockwise.
3. Remove the bolt and outer flange.
5
NOTE
NOTE
NOTE
EN