B+G E-Tech EASTRON SMART X96-5 Bedienungsanleitung Seite 39

2. Holding Register，Function code 03 / 10
Address Parameter
Register
40001 Demand Time
40003 Demand
Period
40005 Slide time
40007 Demand
calculation
method
40011 System Type
40015 Key Parameter
Programming
Authorization
(KPPA)
40019 Parity and
stop bit
40021 Modbus
address
40025 Password
40029 Network Baud
Rate
Modbus Valid range
Protocol
Start Address
Hex
High Low
Byte Byte
00 00 Read minutes into first demand calculation.
When the Demand Time reaches the Demand
Period then the demand values are valid.
Length: 4 byte
Data Format: Float
00 02 Write demand period: 0~60 minutes, Default
60.
Range: 0~60, 0 means function closed
Length: 4 byte
Data Format: Float
00 04 Default 1, min.
Range ：1 ~ (Demand Period -1).
Length: 4 byte
Data Format: Float
00 06
Default 0，
0 = sliding block
1 = fixed block
Length: 4 byte
Data Format: Float
00 0A Write system type: 3p4w = 3, 3p3w = 2 &
1p2w= 1，1p3w=4,
Balance load = 5
Default, 3
Length: 4 byte
Data Format: Float
(KPPA is asked)
00 0E Read: to get the status of the KPPA
0 = not authorized；1 = authorized
Write the correct password to get KPPA, enable
to program key parameters.
Length: 4 byte
Data Format: Float
00 12 Write the network port parity/stop bits for
MODBUS Protocol, where: 0 = One stop bit and
no parity, default. 1 = One stop bit and even
parity. 2 = One stop bit and odd parity.3 = Two
stop bits and no parity.
Length: 4 byte
Data Format: Float
00 14 Write the network port node
Address: 1 to 247 for MODBUS Protocol, default
1.
Length: 4 byte
Data Format: Float
00 18 Read: to get the password of the meter
Write: to program the new password of the
meter
Default 1000
Length: 4 byte
Data Format: Float
00 1C Write the network port baud rate for MODBUS
Protocol, where:
0 = 2400 baud. 1 = 4800 baud.
2 = 9600 baud, default.
3 = 19200 baud. 4 = 38400 baud
Length: 4 byte
Data Format: Float
Smart X96-5 Serie
B+G e-tech and EASTRON
Mode
ro
r/w
r/w
r/w
r/w
r/w
r/w
r/w
r/w
r/w
38